Bare brick is a popular design choice for modern homes, cottages in the countryside, and loft apartments with an industrial feel. However, not everyone has access to it immediately; they hide behind their walls and pray for a sledgehammer’s not-so-gentle touch. Other than exploring faux brick material in West Jordan, UT, you can also consider a DIY project of a faux brick wall, which is also relatively simple.
So, there are primarily two ways to achieve this. One method uses “thin brick” or brick veneer, which is effectively brick tile, while the other uses a hardwood plywood or foam panel that looks like exposed brick.
Step 1 – Preparation
Considering the weight that you’ll be adding to the wall, check to see if the plasterboard is in excellent shape. Use silicone caulk, a putty tool, and a sanded block first to fill up any cracks or dents. Now, remove any wall-mounted switch plates and covers for electrical outlets as well. Meanwhile, don’t forget to take off the picture-hanging nails as well.
Step 2 – Outline the Wall
Your initial course should be as straightforward as possible because of all the following procedures. You can trace a level line across the wall with a laser leveling or spirit level. Also, measuring and drawing a chalk line on the wall is frequently preferable if your floors aren’t level.
Step 3 – Apply the First Layer
Before placing each brick along the reference line, apply construction glue in a zigzag pattern on the back of each one using a caulk gun. Also, verify that it’s upright, not necessarily level.
On edges, outlets, and other spaces where a whole brick won’t fit, you should chop a brick to size or length using the grinder equipped with a masonry wheel. And when cutting, be sure to wear protective eyewear.
Step 4 – Apply the Rest
Use the same method to lay the subsequent courses once the first one lays. The middle of each new brick should sit precisely over a junction below it. And as you create uniform, equal connections between each brick, be sure to employ a tile spacer and hold off till the wall is dry.
Step 5 – Apply Plaster Mix Between Junctions
Mix the plaster mix and water as directed on the bag using the shovel, paddle mixer, and drill. Utilizing a trowel, scoop the mortar mixture into the mortar bag. Put the tip between the bricks and press evenly to force the mortar mixture into the joint. Now, use the mortise and tenon tool to smooth out seams for a wall that looks like exposed brick.
Step 6 – Continue Down the Wall
Use the edge of the preceding panel or a level mark to align the next layer. Take care to get this correctly; the bricks must seem aligned, and the joints between the panels must be as minimal as possible. You should also inspect for any outlets or switches, then transfer the dimensions to the new assembly for cutting before mounting it to the wall and going on to the next panel.
Exposed brick walls may drastically transform a room, and you can look up faux brick material in West Jordan, UT, online. So, depending on how the brick is, you may get a contemporary, industrial effect or conjure up the ambiance of an antebellum brownstone. Also, remember that it is advised to use a product designed for sealing silicone caulk, such as a primer or self-priming paint, if you intend to paint your brick a solid color.
Comments are closed.